Custom phone mount for your car – made for your exact model
We design mounts and organizers for a specific make, model and year – fitted to a vent, trim strip or centre console. We print in PETG or ASA, not PLA.
- Designed for your specific make, model and year
- PETG or ASA – won't warp in a heated-up car
- Fitted to a vent, trim strip or console, not a generic clip
- Model sent for approval before printing
- Personal pickup in Ząbki or shipping across Poland
What we print
Every part is designed for a specific car model – a generic mount from a shop usually either works loose or doesn't fit the interior at all.
Vent phone mounts
A clip matched to the exact shape and spacing of the vent fins in your specific car model.
Trim- or cubby-mounted holders
A phone mount that uses a specific interior part as its mounting point, instead of a suction cup on the windscreen.
Cubby and slot adapters
Inserts fitted to unusual cubbies or empty slots in the dashboard of your specific model.
Seat gap fillers
A filler for the gap between the seat and console, matched to your specific seat model.
Coin and card holders
Small holders for coins and cards, shaped to fit your specific centre console.
Boot organizers
Dividers and holders that tidy up the boot, matched to its shape in your specific model.
Why the material matters
The inside of a parked car easily exceeds 55°C in summer sun – that ruins a part made from the wrong material.
- 01
Why not PLA
PLA starts to soften and deform at around 55°C. A car interior in the sun reaches that temperature easily in summer – a PLA mount simply bends out of shape.
- 02
PETG as standard
We print car parts in PETG, rated to about 75°C – enough for a typical heated-up interior.
- 03
ASA for the most exposed spots
For parts most exposed to sun (e.g. on the dashboard) we suggest ASA, rated to about 95°C and more resistant to UV.
- 04
How to give us your car's details
Make, model and year, plus a photo of the mounting spot with a tape measure against it – that lets us design the exact mount shape.
- 05
Maximum part size
A single printed part is at most 256 × 256 × 256 mm. Larger boot organizers are split into sections.
Indicative pricing
Price depends on how complex the mount is and the material chosen – we confirm it in the quote.
Simple mount (e.g. for a vent)
od 65 zł
One mounting part, PETG, simple shape.
Mount or organizer with a custom fitting
od 110 zł
A more complex shape using a specific interior part, e.g. a trim strip or cubby.
Extra part (e.g. for the console)
od 40 zł/szt.
Price per piece when ordering several matched parts, e.g. organizers for a few slots.
The figures above are indicative market ranges – we give the exact price after receiving the car's make, model and year.
Step by step
- 01
Enquiry
You tell us the car's make, model and year, and send a photo of where the mount will sit.
- 02
Quote
We prepare a mounting shape proposal and give you the price and material (PETG or ASA).
- 03
Design approval
You approve the model in writing – only then do we start printing.
- 04
Printing and inspection
We print the part and check the fit and finish before shipping.
- 05
Delivery
We ship within Poland or arrange personal pickup in Ząbki.
Frequently asked questions
Get a quote for your car mount
Tell us the car's make, model and year, and the mounting spot – we'll reply with a proposal and price.